seat key fob Alhambra Key Problems

Seat's family MPV jumbo is among the top in the class when it comes to conserving resale value. With a new generation model available, it's better than ever.

There are a myriad of reasons why your key fob might not work properly including dead coin battery or damage to the receiver module, water issues, or signal interference. This article will guide you through the steps to get it working.

Water Damage

If your seat ibiza key alhambra key fob can withstand an wash cycle or bath in the ocean or pool then it probably has an amazing waterproof chip but do not make it a habit as exposure to excessive water increases the chance of the key fob being damaged. If the key fob ceases to functioning after exposure to clean water from the tap or rain then simply remove the battery, wipe the electronic component with a paper towel and let it dry completely before putting the battery back in. If the battery is exposed to salt or soapy water it is recommended that you clean the chip using isopropyl alcohol or a electronic cleaner prior to attempting to insert the battery back in.

Faulty Receiver Module

If you have tried a new battery for a button and the key fob does not lock or unlock, it's likely that your receiver module has found a fault. The good thing is that this is a relatively simple repair that is inexpensive, you can remove the battery 12 volts for about a couple of minutes (first remove the negative cable and press the horn button multiple times) to drain any residual electrical current and then reconnect it in reverse order e.g. positive cable first and then negative.

ESP Warning Light - If the ESP warning light is flashing, this is normal and indicates that the car is driving through terrain where the traction between the road surface and tyres is not ideal like snow, gravel or lots of surface water. If the ESP warning light remains flashing, it means there is a problem within the system. It is best to be identified using an iCarsoft i908 seat keys replacement OBD Code Reader kit that will provide you with a specific fault description.

Dead Coin Battery

A dead coin battery is among the most frequent reasons for the keys for the seat to cease to function. The key fob is powered by a small button cell battery that is able to keep it powered. Replace it with a new battery that has the exact dimensions, voltage and specs as the original. When replacing the battery on the key fob, remove the metal clips and make sure that the contacts on the key fob are in good condition and free of corrosion.

If the key fob was exposed to water, like rain or soapy water, it's recommended that you take the battery off and clean the electronic chip using alcohol isopropyl or an electronic cleaner prior to inserting the new battery. The chip is sensitive to moisture and could be permanently damaged. If the key fob does not work after replacing the battery it could be necessary to replace the key fob.

Faulty Receiver Module

If your key fob has stopped working after you replaced the battery but it did not help, or it just stopped working in a sudden manner it is possible that your receiver module might have developed an issue. The receiver module receives radio frequency signals from your remote keyfob, and converts them into electrical commands that are then processed by other modules inside the car.

If the receiver module has suffered a malfunction that prevents it from responding to any of the commands sent by your remote key fob. In this situation it is necessary for a dealer to reprogramme your key fob, and also install an entirely new receiver.

The key fob is fitted with rubber seals that prevent water from entering the electronic chip inside. If you immerse your key fob in salty or soapy water, the chips inside could be damaged. If your key fob isn't able to work, you could try cleaning the chip with isopropyl or an electronic cleaner.

If the keys have been paired but the receiver module has developed a fault, you can try to reboot all the on-board electronics by removing the battery with 12 volts for a few minutes. Connect the battery in reverse (negative cable to positive first). This will reset all electronics onboard and will restore their functionality.

Faulty electronic chip

The key fob comes with a tiny chip which transmits a signal from the key to the receiver module every time the key is used. If the signal received does not match that stored by the car, the immobilizer will disable the engine and stop the vehicle from starting. If the key fob isn't functioning and you are unable to reprogram it the issue could be due to a faulty chip.

The chip inside the key fob isn't a permanent part of the device and could need to be replaced to make it work again. This can be accomplished by removing the key fob from its housing and using a needle or pin to touch each metal clip. If they are corroded or broken, you will require replacement to allow the remote control to function. Make sure that the replacement batteries are the same voltage, size and specification as the original one.

seat spare key Alhambra is a well-known and well-designed model, may be a bit troublesome with specific parts or equipment. For instance, some owners have experienced issues with the auto climate control system, which could be faulty and get stuck in a particular setting. Additionally, the infotainment feature has also been found to malfunction and cause freeze screens.